OUT NOW! MS 76 Rodding Bond
MS 76 Rodding Bond - in the cartridge - for groove reinforcement wih metal, glass fibre and carbon fibre
MS 76 Rodding Bond (System 10:1) is a simple, reliable and economic method of bonding reinforcements in kitchen worktops made of metal (such as iron, steel and aluminium) and a wide variety of plastics (such as glass fibre and carbon fibre plastics). MS 76 Rodding Bond is suitable for unloaded groove bonding up to a temperature of 100° C. The short hardening time
(20 – 40 minutes) enables fast further processing.
Advantages:
- very good adhesion on metal, GRP, CRP
- rapid hardening (work can continue after 20 - 40 minutes)
- suitable for groove bonding indoors up to 100° C
- simple dosing and mixing on account of the cartridge system and therefore reliable application
- high cost effectiveness due to time-saving application and no waste of adhesive
|
|
OUT NOW! Epoxy Remover
Epoxy Remover: "Free of acids - Lyes and CHC"
Removes residues of resins and adhesives from all natural stones,
ceramic tiles and other mineral surfaces.
Due to its very good dissolving and expansion properties Epoxy Remover removes:
- Residues of epoxy resins
- Residues of joint mortar based on epoxy resins
- Sealings based on synthetic resins
- Other resins and adhesive residues
The cleaner can be used on all contaminated surfaces made of natural and artificial stone like granite, gneiss, quartzite, limestone, concrete ashlar, clinker and ceramics.
Technical Instruction Sheet
|
OUT NOW! Darkener Plus
Farbonvertiefer Plus: Ready-to-use special impregnation, which can be dyed using AKEMI Stone Ink. Darkens the colour and structure of fine ground and polished stones.
AKEMI Darkener Plus transports the AKEMI Stone Ink dye stuff into the stone's pore system and has a long-lasting effect. Suitable for all fine ground and polished, absorbent natural and artificial stones, such as marble, slate, Solnhofen slabs, sandstone, granite, gneiss and concrete blocks.
Properties:
- lasting, darkening effect
- intensifies and changes colour in combination with AKEMI Stone Ink
- effective coulour stability
|
OUT NOW! COLOUR BOND!
COLOUR BOND: pre-coloured two-component adhesive in 250 ml cartridges for the fast, simple and reliable attainment of invisible joints for Engineered Stone (such as Caesarstone, Silestone, Zodiaq) as well as natural stone.
Advantages:
- ready-to-use cartridges with colour-matched adhesives
- application reliability: exact dosage and mixing
- economy: no preparation time (no manual dosage and mixing); fast application (direct into the joint); no excess adhesive during the work process; no time needed for cleaning afterwards
- enables the attainment of extremely thin, seamless adhesive joints
- adhesive on the basis of polyester resin, thus no pungent odours as with acrylic bonding systems
- clear product range (reduction to the main colours for engineered stone and natural stone) saves retailers and users costs
- high adhesive strength
- despite extremely high load capacity, disassembly possible without breaking the engineered stone
Technical Instruction Sheet
|
OUT NOW! CRYSTAL CLEAN!
CRYSTAL CLEAN is a fast drying cleaning product for the daily removal of light dirtying on all natural and cast stones as well as fine stoneware, clinker and ceramics. Due to an adjustment free of acids and lyes AKEMI® Crystal Clean does not attack surfaces and joints and is especially suited for marble and limestone. AKEMI® Crystal Clean cleans free of streaks and does not build up layers even if applied freuqently. AKEMI® Crystal Clean is available as a concentrate or in a ready-to-use pump spray bottle.
Technical Instruction Sheet
|
|
|
|
|
|
